Product Specs
-
Compatible with 2” (51 mm) and 3” (76 mm) diameter rollers. Adjacent roller tubes must be the same diameter.
-
Brackets extend 2-1/2" (64 mm) from mounting surface to center line of roller and may be wall- or ceiling-mounted.
-
Coupler system should be installed in an existing pocket or a Type D Pocket. Fascia is available.
-
Coupled units may be installed in 4-5/8” (117 mm) Draper ceiling pockets. Fascia is available.
-
Only motor and crank-operated shades are suitable for coupling. FlexShade 2, Colossal, and LightBloc FlexShade may NOT be coupled!
-
Also available for Dual Roller Motorized FlexShade.
ANSI/WCMA A100.1-2022 Child Safety Standard
Effective June 1, 2024, in compliance with the updated ANSI/WCMA A100.1-2022
child safety standard, all Draper window shades operated by a bead chain will be
furnished with a tensioned hold-down device that is permanently attached and
partially disables the product if not installed correctly. This hold-down should
be installed with tension on the chain.
All bead chain operated window shades will include:
- Permanently installed spring-loaded tensioned hold-down device
- Approved permanent warning label attached
- Approved mechanical fasteners for the tension device included. Screws provided are not suitable for all mounting surfaces. The installer is responsible for secure mounting using
appropriate hardware for the site conditions. Consult with contractors and builders as needed.
If the tension device is not installed with appropriate tension on the bead
chain, the shade will be rendered partially inoperable. If installed
properly, the tension device will prevent the creation of a hazardous loop
and
will maintain tension on the bead chain.
Approved permanent warning label
Learn more about the new child safety standard
At the link below, you can see more information about the new child safety
standard, mounting methods for the tensioned hold-down device, alternatives
to bead chain products, and more.
Click here for more information
Tensioned hold-down device
Supporting Documents
Click the
and
icons to navigate the folders. Click the document name to download.
Part Numbers
-
C177.058SA - Straight Line Coupler-Retractable Shaft Assembly for 2" Roller
-
C177.059SA - Straight Line Coupler Height Adjuster Assembly for 2" Roller
-
C254.006 - 2" Spanner Wrench for 2" Height Adjuster
-
C177.061SA - Straight Line Coupler Retractable Shaft Assembly for 3" Roller
-
C177.062SA - Straight Line Coupler Height Adjuster Assembly for 3" Roller
-
C254.007 - 3" Spanner Wrench for 3" Height Adjuster
-
C069.013 - Angled Coupler
-
- Contact Draper for details
Related Motors & Accessories